To help you seamlessly install and disassemble your MacForge Gen 1 enclosure, follow the step-by-step instructions below. A detailed video tutorial is also available for visual guidance.
Watch the Video Tutorial
For a clear demonstration of the installation and disassembly process, check out the detailed video tutorial below.
Feel free to reach out if you have any questions or need further assistance!
Installation Steps
-
Prepare the Enclosure
Lay the enclosure flat on your desk with the two handles facing upward and the four feet facing downward. Remove the top panel of the enclosure. -
Position Your Mac Mini
Take your Mac Mini, ensuring the power button faces the top-left corner of the enclosure. -
Insert the Mac Mini
Align the Mac Mini horizontally with the enclosure and slowly lower it into the case. -
Secure the Placement
Once part of the Mac Mini is inside, release your hands gently, allowing it to slide into place naturally. -
Attach the Metal Button
Place the provided metal button over the Mac Mini’s power button and replace the top panel of the enclosure. -
Tighten the Screws
Secure the top panel by tightening the four screws provided.
Disassembly Steps
-
Prepare the Enclosure
Lay the enclosure flat on your desk and remove the four screws securing the top panel. -
Access the Top Panel
Use both hands to lift the enclosure and rotate it 90 degrees to the right. Place your index finger inside the Ethernet port and gently push outward until the top panel pops open. -
Remove the Side Panels
Repeat the same process on the opposite side, pushing the top panel gently to open it further. -
Detach Components
Carefully slide out the top panel and metal button, and set them aside. -
Release the Mac Mini
Rotate the enclosure 180 degrees and let the Mac Mini slide out slowly. For safety, place a soft cloth or mouse pad underneath to cushion the landing.
